Search found 5 matches
Search found 5 matches • Page 1 of 1
- Tue Feb 05, 2019 7:54 am
- Forum: Tech Support
- Topic: M3 ID won't hold bed level and other problems.
- Replies: 2
- Views: 246
I have had the problem with the extruders running into each other on the bed level check. In my case, it was because I had canceled a duplication mode print. This means the end script didn't get run, which leaves the extruders in an odd state. Would be nice if octoprint ran the end script when cance...
I have started using the M3-ID profile that comes with S3D as my base. Not only have I seen better print results then I was getting with the profiles from Makergear git repository, but the print times I am seeing match S3D estimates pretty closely.
Go to Settings (wrench) Plugin Manager (about 2/3 down the left side) Click "Get More..." Past the following URL into the from URL field then click install next to it. https://github.com/MakerGear/MakerGear_OctoPrint_Setup/archive/master.zip Reboot Octoprint and the option will be there. Went to the...