Search found 5 matches

by Roland
Tue Feb 05, 2019 7:54 am
Forum: Tech Support
Topic: M3 ID won't hold bed level and other problems.
Replies: 2
Views: 313

Re: M3 ID won't hold bed level and other problems.

I have had the problem with the extruders running into each other on the bed level check. In my case, it was because I had canceled a duplication mode print. This means the end script didn't get run, which leaves the extruders in an odd state. Would be nice if octoprint ran the end script when cance...
by Roland
Tue Jan 15, 2019 8:08 pm
Forum: M3-ID
Topic: print speed
Replies: 5
Views: 712

Re: print speed

I have started using the M3-ID profile that comes with S3D as my base. Not only have I seen better print results then I was getting with the profiles from Makergear git repository, but the print times I am seeing match S3D estimates pretty closely.
by Roland
Sun Nov 11, 2018 8:02 pm
Forum: M3-ID
Topic: M3 ID V0 Probe upgrade install
Replies: 18
Views: 2169

Re: M3 ID V0 Probe upgrade install

I got the probe offset error at the end of a tall print (nearly to the top of the printer's range) but it didn't seem to impact the print at all.
by Roland
Thu Nov 08, 2018 2:47 am
Forum: M3-ID
Topic: M3 ID V0 Probe upgrade install
Replies: 18
Views: 2169

Re: M3 ID V0 Probe upgrade install

Go to Settings (wrench) Plugin Manager (about 2/3 down the left side) Click "Get More..." Past the following URL into the from URL field then click install next to it. https://github.com/MakerGear/MakerGear_OctoPrint_Setup/archive/master.zip Reboot Octoprint and the option will be there. Went to the...
by Roland
Thu Nov 08, 2018 2:30 am
Forum: M3-ID
Topic: M3 ID V0 Probe upgrade install
Replies: 18
Views: 2169

Re: M3 ID V0 Probe upgrade install

Same for me, I submitted a support request.