Search found 6 matches

by Deduin42
Tue Jan 26, 2021 1:54 pm
Forum: M3-ID
Topic: Octoprint module SD card access?
Replies: 14
Views: 52394

Re: Octoprint module SD card access?

I've been waiting for a MakerGear forked Octoprint new release for over two years (see my thread in the software forum). 1.3.6 can't run several plugins that I want to install for improvements to our printing processes.
by Deduin42
Tue Jan 26, 2021 1:53 pm
Forum: M3-ID
Topic: Octoprint module SD card access?
Replies: 14
Views: 52394

Re: Octoprint module SD card access?

I've been waiting for a MakerGear forked Octoprint new release for over two years (see my thread in the software forum). 1.3.6 can't run several plugins that I want to install for improvements to our printing processes.
by Deduin42
Tue Jan 26, 2021 1:44 pm
Forum: Software
Topic: Octoprint version
Replies: 5
Views: 20840

Re: Octoprint version

1.4.0-mgalpha pre-release June 25,2020. No new release of the MG fork in almost 3 years. The official Octoprint is at 1.5.3, just released a week ago.

Is there any way to run the official Octoprint with MG M3-ID?
by Deduin42
Fri Jun 26, 2020 7:01 pm
Forum: Tech Support
Topic: SD card full from timelapses - Octoprint doesn't fully load
Replies: 4
Views: 6819

Re: SD card full from timelapses - Octoprint doesn't fully load

With much gyrations, I was finally able to fix the SD - not sure if it was because of the card being filled up, but one of the "start_...elf" boot files appeared to have gotten corrupted. After replacing them with new copies from a fresh Raspbian install on another SD, I was able to boot fully into ...
by Deduin42
Mon Jun 22, 2020 1:25 pm
Forum: Tech Support
Topic: SD card full from timelapses - Octoprint doesn't fully load
Replies: 4
Views: 6819

SD card full from timelapses - Octoprint doesn't fully load

I'm having an issue where it appears the SD card has filled up with timelapses, and now Octoprint doesn't fully load. It brings up the basic interface, but doesn't connect to the printer, and clicking the login button doesn't do anything. (Makergear M3-ID) Prior to this symptom, I had tried to uploa...
by Deduin42
Thu Jun 27, 2019 1:28 pm
Forum: Software
Topic: Octoprint version
Replies: 5
Views: 20840

Octoprint version

Is there any anticipated releases for newer versions of the Makergear fork of Octoprint? Current released version 1.3.6 was in March over a year ago, and the 1.3.10.1 pre-release test build hasn't been updated since December. The original Octoprint is at 1.3.11 and enables use of a lot of newer plug...