Search found 3 matches

by ratslayer
Wed Mar 20, 2019 8:23 pm
Forum: Tech Support
Topic: Issue printing any object on my M2
Replies: 5
Views: 595

Re: Issue printing any object on my M2

This issue has been resolved. The printer is working as expected after tightening the pulley set screw and other fasteners.

Thanks again for the help!
by ratslayer
Tue Mar 19, 2019 10:22 pm
Forum: Tech Support
Topic: Issue printing any object on my M2
Replies: 5
Views: 595

Re: Issue printing any object on my M2

Thanks for all the feedback! I found the following - Set screw on the pulley was loose. Pulley was tight but could see evidence of spinning on the shaft. - Couple of fasteners were loose on the extruded assembly I am going to disassemble everything and clean, lube and tighten. Will provide a final u...
by ratslayer
Sat Mar 16, 2019 7:47 pm
Forum: Tech Support
Topic: Issue printing any object on my M2
Replies: 5
Views: 595

Issue printing any object on my M2

Any idea what might be causing this? I fired up the printer after about two months of inactivity and now all the prints keep slowly shifting over to the right. It was printing fine before. This happens with anything I try to print. The objects render correctly but do not print correctly. See images ...