Search found 3 matches

by mark_tec_wiz
Sat Dec 24, 2022 2:55 pm
Forum: Tech Support
Topic: *FIX* extruder stops extruding
Replies: 3
Views: 12445

Re: *FIX* extruder stops extruding

I have 4 maker gear m2 and they run about 12 hours a day, I get this problem every year. I have a couple of PTEG parts and they seem to last longer. I find PTEG hard to print but for this part it is worth it.
Mark
by mark_tec_wiz
Wed May 19, 2021 3:51 pm
Forum: Getting Started
Topic: slipping filament - motor shaft wiggly
Replies: 7
Views: 23410

Re: slipping filament - motor shaft wiggly

The drive gear should not be wiggly right to left up and down. If it slips in and out tighten the set screw. I had to replace the roller bearing. The number is ~~~ Ball Bearings, 698RS Bearing Deep-Groove Ball Bearings 8 x 19 x 6mm / 0.3 × 0.7 × 0.2in Rubber Sealed Bearing https://www.amazon.com/gp/...
by mark_tec_wiz
Sun Feb 09, 2020 7:20 pm
Forum: General Discussion
Topic: Octoprint and M2 print Bed leveling
Replies: 5
Views: 15334

Re: Octoprint and M2 print Bed leveling

Zemlin The program that was referenced in this post works like your octoprint scripts. Except it saves the z start point http://forum.makergear.com/viewtopic.php?f=7&t=4762&p=38134#p38134 This gcode saves the z start point after reading it and then manually adjusting the number but I don't know how ...