Yeah, I'm using Simplify3D - I'll just keep using a small piece of tape to catch it or a piece of paper towel on top of the electronics box where it'll hit.
Thanks guys!
Search found 4 matches
- Mon Apr 21, 2014 6:02 pm
- Forum: Tech Support
- Topic: Anchor Printing off of the edge of the print bed.
- Replies: 3
- Views: 6579
- Mon Apr 21, 2014 6:00 pm
- Forum: General Discussion
- Topic: Removing PLA Prints from Glass Bed?
- Replies: 4
- Views: 8696
Re: Removing PLA Prints from Glass Bed?
Thanks folks! Think I'll try the glue stick method next. Blue Tape is just too much of a hassle.
- Sun Apr 20, 2014 1:03 pm
- Forum: Tech Support
- Topic: Anchor Printing off of the edge of the print bed.
- Replies: 3
- Views: 6579
Anchor Printing off of the edge of the print bed.
Whenever my print begins and it goes to print the anchor, the anchor is extruded off the side of the print bed - I have to have blue tape in that spot or the hot filament would fall right on top of my electronics box. Any idea what is causing this and how to fix?
Thanks,
Jake
Thanks,
Jake
- Sun Apr 20, 2014 10:54 am
- Forum: General Discussion
- Topic: Removing PLA Prints from Glass Bed?
- Replies: 4
- Views: 8696
Removing PLA Prints from Glass Bed?
I'm having a helluva time getting prints off of the glass on the bed when using blue painters tape. Just had to order a replacement piece because I shattered the original trying to remove a printed piece. I've looked and looked, but having a hard time finding any info about removing a print. Everyon...