Search found 5 matches
- Fri May 29, 2015 3:02 am
- Forum: How-to/Guides/Tips
- Topic: How To - Pausing a print at a specific layer. (Simplify3D)
- Replies: 37
- Views: 119828
Re: How To - Pausing a print at a specific layer. (Simplify3
Great tip; Thanks!
- Fri May 29, 2015 2:58 am
- Forum: How-to/Guides/Tips
- Topic: 100 micron success?
- Replies: 6
- Views: 10649
Re: 100 micron success?
IMG_4690.JPG IMG_4691.JPG The calibrations definitely have improved my prints. I still have a bit of a hard time with really fine detail on tiny structures which I suspect might be simply a limitation of extruder based FDM. The attached pictures are from an attempted bracelet print in which a lot o...
- Thu May 14, 2015 7:15 pm
- Forum: How-to/Guides/Tips
- Topic: 100 micron success?
- Replies: 6
- Views: 10649
Re: 100 micron success?
Printing at low layer heights requires finer tuning than at higher, because so little filament is being fed at a time. Calibrate your extrusion: http://forum.makergear.com/viewtopic.php?f=3&t=1964 Then make sure your first level height is perfect, using the same test print: http://www.forum.makerge...
- Thu May 14, 2015 6:58 pm
- Forum: How-to/Guides/Tips
- Topic: 100 micron success?
- Replies: 6
- Views: 10649
Re: 100 micron success?
What have you done to dial in the extrusion widths and multipliers? There's a guide floating around the forums that'll pop up soon explaining how to do all that, if you haven't. I haven't done anything directly with widths and multipliers as far as I can tell, but I did try the 100 micron "ultra" S...
- Thu May 14, 2015 4:24 pm
- Forum: How-to/Guides/Tips
- Topic: 100 micron success?
- Replies: 6
- Views: 10649
100 micron success?
I am at the point that I am getting pretty good results with the 200 micron prints using S3D and my new M2 with the V3b. I have not figured out how to get good looking prints at 100 microns. I get globs, lost details, floating strings, etc. Anyone out there getting success at 100 microns that could ...