Search found 3 matches
- Mon Jan 08, 2018 9:43 pm
- Forum: Tech Support
- Topic: New fan and thermistor aren't working
- Replies: 5
- Views: 6544
Re: New fan and thermistor aren't working
Thermistor is reading 0. Not sure about the firmware version. Where do I check that?
- Mon Jan 08, 2018 9:00 pm
- Forum: Tech Support
- Topic: New fan and thermistor aren't working
- Replies: 5
- Views: 6544
Re: New fan and thermistor aren't working
Follow up:
After checking it with the printer head heating up, I have voltage to HEAT 0 but I still can't get the thermister to read. HEAT 0 varies wildly between 9 and 14 volts. M2 Quick Start doesnt see the Heat Extruder as heating up but it is hot. Still no voltage to FAN 0.
After checking it with the printer head heating up, I have voltage to HEAT 0 but I still can't get the thermister to read. HEAT 0 varies wildly between 9 and 14 volts. M2 Quick Start doesnt see the Heat Extruder as heating up but it is hot. Still no voltage to FAN 0.
- Mon Jan 08, 2018 7:19 pm
- Forum: Tech Support
- Topic: New fan and thermistor aren't working
- Replies: 5
- Views: 6544
New fan and thermistor aren't working
Long story short, I scored a makergear M2 pre-2015 model with the Z motor mount broken off. I ordered a new motor mount and ran the M2 Quick Start guide. I leveled the bed and the bed heated fine. However it wasnt reading the printer head as heating up. After confirming the head was hot, I figured t...