Just wondering what you all use to decide if you have enough filament on the roll to get that last print done? I have one more print to do but not sure if I have enough. Do I weight it than subtract what reel weighs? If so what does an Esun black PetG filament reel weigh. Sorry if this is on here so...

That fixed it thanks Jim

Will give it a try.... I know they had 3200. I was trying to get the part done quicker

Internal rectangular
External rectangular
Default print speed 4000

Simplify 3D

Interior fill % - 20
Outline overlap - 10%
Infill extrusion width - 130%
Minimum infill length - 4.00 mm
Print sparse infil every 1 layer
Infill angle offset 45
-45

I have a V3b and using settings that Jules has on page 27. Prints great at 100% Infill but when I try to go with 20% infill it clogs everytime it hits the first infill layer it gets about 1/4 into the layer before clogging. It seemes to be almost draging on the first round around the outside before ...

The good news is Im learning.... the bad news Im bugging all of you. Hot End needs to be hot for filament drive motor to move. Was looking at G code terminal and saw (echo cold extrusion prevented cold extrusion prevented) Another lesson learned in this world of 3d printing. The good thing is I lear...

I have the motor off and down to internal pinion gear. I moved it down and plugged it into Z axis motor and motor runs. All other motors and fans are working fine.

Bought it assembled has been working great for about a week. I jammed the filament drive today and hasn't worked since. Connections look fine no bent pins.

Filament Drive motor seems to not be getting power. I had a jam up in the filament drive but now it wont do anything. I moved the motor down and pluged into z axis motor as they appear to be the same motor and it works fine. I submitted a ticket to support but thought I would ask here incase it is s...