Search found 4 matches

by Msculpt
Fri Apr 15, 2016 6:17 pm
Forum: Modifications
Topic: Mic 6 tooling plate
Replies: 212
Views: 52798

Re: Mic 6 tooling plate

Has anyone who has made these ever had the plates arrive from Mcmaster and find they weren't flat? I just made three and didn't check them for flatness first. Only when I went to install them did I realize they were totally warped. The worst one has an 1/8" crown from corner to corner. It may have b...
by Msculpt
Thu Apr 14, 2016 11:41 pm
Forum: Modifications
Topic: Heated Bed Wire Support Bracket
Replies: 1
Views: 1071

Re: Heated Bed Wire Support Bracket

Important: I just realized that if you have a thin glass build surface and happen to have a V4 hotend on a machine without the heater wire support on the build plate, that using this bracket may give you clearance issues and bump against the nuts on the underside of the X axis rail when you set the ...
by Msculpt
Sun Mar 13, 2016 4:44 am
Forum: Modifications
Topic: Heated Bed Wire Support Bracket
Replies: 1
Views: 1071

Heated Bed Wire Support Bracket

I was in a state of denial...could it ever happen to me....naaaawww...then my wires broke. I looked back at all the posts I ignored about this when I got my M2 and couldn't really find a solution I liked, so I made one.

http://www.thingiverse.com/thing:1411662
by Msculpt
Tue Aug 18, 2015 5:54 am
Forum: Filament
Topic: ColorFabb copperfill
Replies: 2
Views: 1946

Re: ColorFabb copperfill

I tried some with the stock extruder mount and V3b and the teeth on the drive gear absolutely shredded the filament no matter how the tension was set, made a mess and ultimately caused a number of other issues. I now have an E3dV6 but have not tried again. I will give it a shot sometime soon, I need...