Thanks, jsc.. I had my bridge speed turned down, but not that low. I also didn't have my multiplier bumped down. I'll give both those a shot.

Thanks, again.

Still fairly new-ish, but I've gone through a couple of spools worth of stuff so far (mostly simple things).. Trying some trickier prints and I seem to have issues whenever overhangs get too tricky. So I've tried printing this a few times now : http://www.thingiverse.com/thing:925556 and it always l...

Thanks for all the replies! I started playing around with lowering the temperature a little, and found that around 200 (instead of the recommended 215), when I manually extrude, I get nice smooth flow where before I would get a sort of rapid jittery flow.. It also lessened the oozing. That seems to ...

Thanks for the quick response! Much appreciated. I believe my z-stop is set OK.. I actually check it before every print (the nut sometimes jiggles loose and shifts the bolt enough to throw things out of whack).. I think my bed is leveled OK, but I'll double check. When I just manually extrude, it'll...

Hi all, New here after recently purchasing a M2 kit, and hoping to get some tips for some issues that I'm having. I've printed several models already, and for the most part, they came out pretty well. What I'm having issues with, however, is within the crucial 2-3 seconds of starting the print. I ty...