Need some electrical help; had 3 m2 with v4 Extruder running when power went out. After power came back 2 are working fine, but 3rd one isn’t. Extruder fan and pc can not running (tested both fans they are fine) Extruder will not heat up; changed both of the really small fuses in board but no change...

Making some lithopanes for my daughter; getting severe ghosting I tried lowering acceleration down to 1000, didnt see much change Is there a G code command to control jerk? This is what I have in my starting script, is this correct? m201 x1000 y1000; Print ACC m202 x1000 y1000; Travel Acc m204 s1000...

I have 2 quick questions about the stepper motors:

1. My X-axis motor is a little squeaky lately. Am I able to grease or oil it?

#2 I added dampeners to my x and y axis motors; am I able to add one to the extruder motor? Would that help at all?

Thanks guys!!

I am having some of the same issues as you, tried most everything you did. In the end what main things finally worked?

I know I have read it before, but cannot for the life of me find it

I read you get the bed close to the nozzle, then use a setting in S3d to fine tune it

Which setting is that?

Working on updating the posts on my porch. I was just going tio use wood or buy stone veneer from Lowes, when I realized, why not try to print it? A few obstacles I have run into, and could use some advice First, I am assuming ABS would need to be used to avoid heat problems. What sort of paint/fini...

Im not sure how crippled the student version is really; I have solidworks, but may get this for my daughter!

My daughter is 14 years old, and an amazing artist

I have taught here how to make dxf files from here sketches, etc, but then I have to thicken them for her to print (I use Solidworks)

Is there a free or cheap program I can get for her, that she could use to make here own 3d prints?

Thanks everyone!

Go her all oiled up and lowered the x/y speed

Been working great so far!