Search found 3 matches
- Sun Apr 12, 2020 3:04 pm
- Forum: Tech Support
- Topic: MakerGear M2 motors won't jog or home
- Replies: 2
- Views: 4483
Re: MakerGear M2 motors won't jog or home
Thanks for your input. Tech support did not have me send the G28 command. When I sent it it did produce a brief "buzz" that I assume was a motor trying to move. Jog and home commands still do nothing although I can produce a buzz when clicking a +X command. The log for G28 is simply followed by a st...
- Fri Apr 10, 2020 8:36 pm
- Forum: Tech Support
- Topic: MakerGear M2 motors won't jog or home
- Replies: 2
- Views: 4483
MakerGear M2 motors won't jog or home
After following the recommendations suggested by MG tech support, my problem persists; namely that none of the motors on my M2 v4 will run. They neither jog nor home. This machine was stored in my closet for about 2 1/2 years in a plastic garbage bag. When extracted it I was happy to see that it loo...
- Sat Nov 21, 2015 4:59 pm
- Forum: General Discussion
- Topic: Power supply in vertical orientation ok?
- Replies: 1
- Views: 3301
Power supply in vertical orientation ok?
Newbie question: Is it ok to operate the M2 24V power supply vertically? I'm a little short on space and vertical works best for me. Thanks for any tips, warning or assurances.