Does anybody know where to get the female Molex connector going from board to Extruder Stepper Motor?

Thank you,

Naz

Thank you for your help all! a lot of stuff happened over the last week. My extruder motor decided to fail. The excellent folks at MakerGear verified that it was in fact the motor and offered me a replacement immediately. while this happened, I got a shipment of feeler gauges, I re-leveled the bed, ...

Hummmmmmm, I didn't excpect that, but the only way for me to fix this is to reduce my extrusion multiplier from 100% to 60% is slic3r. I didn't expecting that it is over extruding thaaat much. I will double check later to make sure that my Steps Per MM are correct on the extruder. I ordered the prin...

Greetings Folks, I just got my Makergear M2 last week. It is my first Cartesian printer. I normally worked with Deltas. Very happy with the quality. However, I am seeing this issue during my prints that I haven't experienced before. I was hoping someone seen this and might have a solution. Issue Des...