Search found 7 matches
Search found 7 matches • Page 1 of 1
From more observations, it seems it only does it when it's doing infill and the quicker sections of the perimeter. Doesn't seem to do it on the outer perimeter when it's going slower.
Hi guys, Only recently has this started but I'm getting this strange noise from what I think is coming from the X Axis. And also sometimes when the print starts the print bed seems to "get stuck" and not rise up. Any and all help would be great as I'm loving the quality this machine is printing at! ...
I haven't really looked into the reduce layer speed based on print time, but the setting which it is set to at the moment is lower than 15 secs and reduce upto 20% and no that small part was a failed attempt at printing a little robot I found on thingiverse that had built in joints...until his head ...
- Mon Feb 01, 2016 9:00 am
- Forum: General Discussion
- Topic: Fan Shroud Question
- Replies: 5
- Views: 3424
This is the one that I made from a few designs that I found. One design I found blew the air to far behind where it was being extruded and this one blows closer and around the sides. I've seen much improvement since using this one.
I did manage to get the whole print done and learned a ton in the process, still got awhile to go in knowing all about it though as expected :) 20160131_144632.jpg I found out it was a cooling issue and has since diminished/gone away with the addition of my new fan duct I designed. 20160131_103235.j...
Hi guys, This is my first time on here as I just got my M2 3 days ago :D Been spending all those days trying to calibrate it and I thought I got it right when I had a whole day of printing perfect prints haha. Then this started happening again. Image 1.jpg Image 2.jpg Image 3.jpg I have tried slowin...