If you home and it is correct, then I would look at your slicer code to make sure something did not change there. Z offset specifically. If you home and it is correct, then I would look at your slicer code to make sure something did not change there. Z offset specifically. +1 on that suggestion. Ch...

The test file on the disk might have been set up using the settings for the V3B nozzle, which has the bed sitting a lot lower. Try a different print over USB. I didn't print the test files from the SDCard i printed the test calibration file provided in this thread. http://forum.makergear.com/viewto...

Hello everyone, I have had my M2 for a little over a month now. So far i have created some pretty awesome prints and have been satisfied with my purchase. This is my first experience with 3D printing so bear with me. Before my last print I noticed that the bed was uneven. The left side of the glass ...