Search found 4 matches

by mv3dnerd
Thu Jan 05, 2017 5:11 am
Forum: General Discussion
Topic: The MakerGear Website - input requested
Replies: 81
Views: 293411

Re: The MakerGear Website - input requested

" What's Next" from MakerGear would help with decisions on whether to wait for MG's next printer (or 3D Scanner?), and the accompanying quality, performance, and support, ... or, to begin shopping. The prusa i3 mk2 looks pretty good. I like this idea. The Prusa i3 mk2 does look pretty good, and it ...
by mv3dnerd
Thu Jan 05, 2017 1:31 am
Forum: Modifications
Topic: BLTouch Auto Leveling Sensor
Replies: 63
Views: 229178

Re: BLTouch Auto Leveling Sensor

I saw questions regarding the use of the BLTouch sensor and the newer printers. I have a Rev. E and have added an inductive sensor. I have made a post on the forum going through some of the steps including updating the Marlin firmware using mesh bed leveling. Here is the forum post http://forum.make...
by mv3dnerd
Wed Jan 04, 2017 4:08 am
Forum: Modifications
Topic: How You Too Can Achieve Printing Nirvana
Replies: 65
Views: 81179

Re: How You Too Can Achieve Printing Nirvana

Hey all, I have seen many discussions on this forum regarding modifications to the MakerGear M2. I have done a few modifications to my printer and I think these modifications are key to the success of my printing. Modifications have included MIC 6 aluminum plate with the use of PEI or Ultem, inducti...
by mv3dnerd
Thu Jun 02, 2016 9:02 am
Forum: Modifications
Topic: PEI Bed Surface
Replies: 161
Views: 180858

Re: PEI Bed Surface

Been following this thread for a while. Using the PEI from zoro.com and 3m 468MP tape with MIC 6 al. It works ok but I am in the process of getting the plate milled with the PEI stuck on it. I have a friend who works at a machine shop to help me with this. My question is has anyone tried this http:/...