Thanks, I am modelling a true ducted blower attachment to fully encircle the hot tip output. This will give slotted air output from the blower right near the filament lay area. Most of the manifold vents I have seen are open bottomed and this won't actually do much at all. Currently the blower fan r...

Odd that there is a fan blowing over the nozzle cooling fins (I appreciate that is why those fins are there). I can only assume it is to stop the heat softening the filament before it hits the heat zone. Allowing the feed mech to operate. So I would not lose a fan, the fan that keeps the plastic coo...

Yes, Comic Sans, a crime against sanity.

Well, I was under the impression if I got a metal head then I could lose the head fan completely, or do i need a full metal head for that (without the peek tube)?

It is all working fine but just asking.

Hi Some advice please. I am tempted to purchase one of these: http://www.ebay.co.uk/itm/171146824305?_trksid=p2060778.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT For my M2 standard printer with single power supply. 24v i think. As I understand it I would no longer need the primary head cooling fan- As...

Thanks all. I had sort of assumed S3D would have the offset built in as it has a profile specific to M2?

R

Thanks all, JSC, you Sir are a brick. worked a treat.

Have reversed my lettering to give smooth side on face, running tests now...

Hi, am using S3D and I also use Repetier with slic3r.

I thought it was to do with nozzle output width in relation to model profile?

Hi

One of my M2 machines has the new head requiring the 20 degree temp increase to allow for sensor position.

Does simplify3D allow for this?

Currently I am putting 215 to 235 on for temp to approximate 195 to 215, it seems to be ok.

Anyone know please?

R

Hello from England. I now finally have 2 makergear M2s and have one fired up. Terrific results thus far. I have an issue I think is code related and would like a fix please (or nozzle diameter in relation to model). I like to print keyrings and stuff for the young cousins so will often spell there n...

Hi

I have come across using PEI coating or sheet as a base board for cold and heated prints as it seems to have the right combination of stick and hold for reliable prints.

Anyone tried it?

R