Search found 3 matches
- Fri Dec 23, 2016 4:51 am
- Forum: General Discussion
- Topic: Making an M2's Nozzle Self Cleaning & gcode
- Replies: 4
- Views: 8280
Re: Making an M2's Nozzle Self Cleaning & gcode
I ended up tweaking the S3D default scripts when I had the same problem, and with the current config I almost never have to use the tweezers (as long as the nozzle is clean... ). IIRC the tweaks were, on ending to retract the filament ~20mm after the print is done (less ooze solidifying on the nozzl...
- Sun Oct 30, 2016 1:59 am
- Forum: Modifications
- Topic: MIC6 preorder number 2 *READY FOR SHIPPING*
- Replies: 90
- Views: 109511
Re: MIC6 preorder number 2 *READY FOR SHIPPING*
Finally got time to set this up and make a few prints this week. Works great! A couple things I encountered: - The surface temperature was about 10C lower than the set point for the heated bed. Turned out my heated bed sags a bit in the center, so I put some thermal paste between the two and the tem...
- Tue Aug 30, 2016 5:48 pm
- Forum: Modifications
- Topic: MIC6 preorder number 2 *READY FOR SHIPPING*
- Replies: 90
- Views: 109511
Re: MIC6 preorder number 2 *LAST CALL*
Interested in 1 with PEI.
Thanks!
Thanks!