Search found 4 matches

by rwilly
Sat Jan 13, 2018 6:12 pm
Forum: Tech Support
Topic: Printing stops and then starts again
Replies: 1
Views: 3626

Printing stops and then starts again

THis just started to happen and it does this on small fast parts. The printer will pause on it's own and then start up again. A couple of times it did not continue the print and I had to emergency stop to start over. This is starting to happen on everything I print now. Some prints get completed som...
by rwilly
Thu Mar 30, 2017 2:59 am
Forum: General Discussion
Topic: Jammed Filiment Feed Gear.
Replies: 0
Views: 5237

Jammed Filiment Feed Gear.

My printer stopped printing in the middle of a job and acted like the nozzle may have become plugged. I removed the filament and tried a new piece and it started to extrude and then stopped. I moved the fans to see the feed gear and found at some time a piece of filament came off and was jammed betw...
by rwilly
Thu Mar 30, 2017 2:07 am
Forum: Getting Started
Topic: Print bed not heating
Replies: 3
Views: 7998

Re: Print bed not heating

Call this an operator error. I checked the main cable where it plugs into the machine and found that I plugged it in at an angle and the end socket wasn't attached. Plugged it in properly and.... it works great now. You have to be smarter than the machine.
by rwilly
Tue Feb 14, 2017 10:21 pm
Forum: Getting Started
Topic: Print bed not heating
Replies: 3
Views: 7998

Print bed not heating

Just got my M2. Went through all the bells and whistles in the Quick Start program. Everything worked okay until I got to the print section and turned the print bed heater on. It won't go any higher than 25 degrees C. Supposed to go to 70 degrees C. Due to this my M2 won't even print the test pieces...