Search found 4 matches
- Sat Jan 13, 2018 6:12 pm
- Forum: Tech Support
- Topic: Printing stops and then starts again
- Replies: 1
- Views: 3681
Printing stops and then starts again
THis just started to happen and it does this on small fast parts. The printer will pause on it's own and then start up again. A couple of times it did not continue the print and I had to emergency stop to start over. This is starting to happen on everything I print now. Some prints get completed som...
- Thu Mar 30, 2017 2:59 am
- Forum: General Discussion
- Topic: Jammed Filiment Feed Gear.
- Replies: 0
- Views: 5263
Jammed Filiment Feed Gear.
My printer stopped printing in the middle of a job and acted like the nozzle may have become plugged. I removed the filament and tried a new piece and it started to extrude and then stopped. I moved the fans to see the feed gear and found at some time a piece of filament came off and was jammed betw...
- Thu Mar 30, 2017 2:07 am
- Forum: Getting Started
- Topic: Print bed not heating
- Replies: 3
- Views: 8070
Re: Print bed not heating
Call this an operator error. I checked the main cable where it plugs into the machine and found that I plugged it in at an angle and the end socket wasn't attached. Plugged it in properly and.... it works great now. You have to be smarter than the machine.
- Tue Feb 14, 2017 10:21 pm
- Forum: Getting Started
- Topic: Print bed not heating
- Replies: 3
- Views: 8070
Print bed not heating
Just got my M2. Went through all the bells and whistles in the Quick Start program. Everything worked okay until I got to the print section and turned the print bed heater on. It won't go any higher than 25 degrees C. Supposed to go to 70 degrees C. Due to this my M2 won't even print the test pieces...