Search found 5 matches
- Tue Sep 03, 2019 3:41 am
- Forum: Tech Support
- Topic: M3 not booting
- Replies: 1
- Views: 4246
M3 not booting
I was traveling for a couple of weeks and the M3 was on for the whole time in my basement. Today, I was not able to make the connection from my browser and observed that the fan was not turning. There was no ping reply. After power cycling and pushing the reset button, the fan didn't start, but ther...
- Mon Aug 07, 2017 4:56 am
- Forum: General Discussion
- Topic: M3 Positive Surprise
- Replies: 0
- Views: 10568
M3 Positive Surprise
I am learning to use my new M3 in baby steps. My intention is to get an IKEA table and box for the printer, but I left it in the basement on top of the empty shipment box. It felt strong enough. I had started the 3DBenchy and after plate and extruder heating, After it had been printing around 10 min...
- Sun Jul 30, 2017 5:33 pm
- Forum: Getting Started
- Topic: M3 Wi-Fi Connection Problem
- Replies: 12
- Views: 24179
Re: M3 Wi-Fi Connection Problem
If you got the small tablet for your M3, it has Fing installed and Fing finds your OctoPrint among all other nodes in your network.
- Wed Jul 26, 2017 10:31 pm
- Forum: Getting Started
- Topic: M3 Unboxing
- Replies: 6
- Views: 18808
Re: M3 Unboxing
Thanks for rapid replies. I was trying to be as careful as possible and to avoid to use excessive force. In my case, the printer was slightly stuck to the bottom dark foam. By using some force, I was able to lift the printer free.
- Wed Jul 26, 2017 8:13 pm
- Forum: Getting Started
- Topic: M3 Unboxing
- Replies: 6
- Views: 18808
M3 Unboxing
Sorry for a very trivial question. M3 is my first 3D printer and I received it today. It is very nicely packaged and perhaps protected more than enough. My problem is in removing all the protective dark material around and inside the printer frame. I was able to remove several pieces, but the bottom...