Search found 4 matches

by Bernie X
Fri Jan 26, 2018 7:25 pm
Forum: How-to/Guides/Tips
Topic: Removing the hot ends from the M2 Dual
Replies: 1
Views: 5451

Removing the hot ends from the M2 Dual

Does anyone know how to remove the hot ends from the X carriage? There appears to be a brace of sorts, mounted between the heater block and the hot end connectors, keeping the hot end wiring in place.
by Bernie X
Fri Dec 29, 2017 2:19 pm
Forum: M3-ID
Topic: M3 ID PVA + PLA builds
Replies: 4
Views: 9592

Re: M3 ID PVA + PLA builds

I have the M3ID and I love it. I have used PVA with stringy, but good results. I recently discovered BVOH. This is water soluble like PVA. It actually dissolves faster and cleaner than PVA and it prints like PLA, little or no stringing and oozing. Verbatim is the only one that makes it as far as I ...
by Bernie X
Thu Dec 28, 2017 1:56 pm
Forum: General Discussion
Topic: M2 Dual vs M3
Replies: 1
Views: 5787

Re: M2 Dual vs M3

Found this while searching for PolySupport. I was facing the same conundrum, and ended up with the M2 Dual. What did you end up going with?
by Bernie X
Thu Dec 28, 2017 12:52 pm
Forum: How-to/Guides/Tips
Topic: How To - Pausing a print at a specific layer. (Simplify3D)
Replies: 37
Views: 113839

Re: How To - Pausing a print at a specific layer. (Simplify3

jsc wrote:The pause gcode depends on the host software you are using. If you are using S3D or OctoPrint, M0 is correct. If you are using Pronterface or Repetier Host, it is @pause. viewtopic.php?f=3&t=1584
Pronterface doesn't recognize @pause