Search found 13 matches

by kskiff7034
Wed Jun 06, 2018 7:26 pm
Forum: Getting Started
Topic: First benchy -- tips?
Replies: 2
Views: 1029

Re: First benchy -- tips?

I've only done one of the pre-sliced example prints which was the keychain and it came out fine, but that's not very technical. I'd like to be able to import the settings from one of those pre-sliced ones and try the benchy with that, but I'm not quite sure how to import settings in S3D from a gcode...
by kskiff7034
Wed Jun 06, 2018 2:30 pm
Forum: Getting Started
Topic: First benchy -- tips?
Replies: 2
Views: 1029

First benchy -- tips?

I got my makergear m3 ID rev 1 yesterday. I went through the setup and everything looked fine. I imported the S3D profiles for the printer as well. Attached below is my first benchy. The detail work on the bottom and other areas is flawless, but there are issues as you can see. Is my temp too low? S...
by kskiff7034
Tue Jun 05, 2018 11:52 pm
Forum: Tech Support
Topic: Can't log into access point
Replies: 1
Views: 408

Can't log into access point

I just got my 3d printer today. I got it all set up and it was working great, but then I was trying to configure it for remote access and must have messed something up because my login information to octoprint wasn't working anymore. I used the re-set button and held it for 60 seconds, but now when ...