If you are "SELLING" kits to be beta tested... this post is nothing but an advertisement/marketing campaign.
Search found 893 matches
- Mon Jul 01, 2019 2:42 pm
- Forum: Modifications
- Topic: Flexible Magnetic Build Surface for the M2/M3
- Replies: 29
- Views: 10552
Beta testing has nothing to do with promoting anything.... this is a marketing ploy masquerading as a "Beta Test" plain and simple.... this line is a dead giveaway.
if you run any pages, social platforms or youtube channels
- Sat Dec 01, 2018 9:55 pm
- Forum: How-to/Guides/Tips
- Topic: printing bones, bottom knuckle curls up, how to fix?
- Replies: 6
- Views: 3901
I would probably split the tip off so it prints on a flat area then just print the tip separate and glue them together. You could probably do this right in S3D but dropping the part below the print surface. (z offset) Just import two of the same part and flip one over. You just have to make sure the...
Ninjaflex needs to be dried, is that correct? I did not do that prior to first use.. How bad does is suck up moisture.. PLA like or Nylon like?? I don't think so... its flexible so it's not going to get brittle. I have an off brand of flex (Zen Toolworks) that I've had for 4 years and it still prin...
It all depends on how good the filament is as well as how it was stored. Like you I store my filament in Plastic tubs (my lids have seals) with silica gel packets and I have Makergear filament that came with my printer and is 4+ years old that is still fine. Then I have other cheap stuff that is les...
- Tue Sep 11, 2018 4:38 am
- Forum: General Discussion
- Topic: Introducing Ultra One
- Replies: 21
- Views: 10285
- Tue Sep 04, 2018 12:40 am
- Forum: Software
- Topic: Octoprint damaged - how do I re-install?
- Replies: 3
- Views: 3480
You can try the Makergear Github page I know there is some Octoprint stuff there but I've never looked at it so I'm not sure if its what you need or not.