Search found 47 matches

by KiddingMe
Sat Jan 10, 2015 3:53 am
Forum: Getting Started
Topic: Cracked the borosilicate trying to remove pla print...
Replies: 15
Views: 5298

Cracked the borosilicate trying to remove pla print...

So I noticed some of my larger prints were lifting at the edges away from the borosilicate surface so I began printing with elmers glue stick which seemed to work great...until I cracked the glass trying to pry a 40mm calibration cube off with a putty knife. Printing with makergear black pla. Bed: 6...
by KiddingMe
Thu Jan 08, 2015 5:53 am
Forum: Tech Support
Topic: Printing from SD card...
Replies: 3
Views: 1142

Re: Printing from SD card...

Ok. Thanks.

I thought you would want to click disconnect or close S3D before pulling the usb cable.
by KiddingMe
Thu Jan 08, 2015 4:33 am
Forum: Tech Support
Topic: Printing from SD card...
Replies: 3
Views: 1142

Printing from SD card...

Is it normal that you must remove the usb cable after starting a print from SD card in order to get it to not pause? When I try pressing Disconnect or closing S3D the print pauses and I cannot figure out how to restart it. It only seems to continue printing if I pull the usb cable which seems odd to...
by KiddingMe
Wed Dec 31, 2014 9:50 pm
Forum: Kit Assembly
Topic: Kit assembly questions
Replies: 10
Views: 6040

Re: Kit assembly questions

I thought that at first too but looking back at the assembly guide again it appears I have it correct.
by KiddingMe
Wed Dec 31, 2014 3:36 am
Forum: Kit Assembly
Topic: Kit assembly questions
Replies: 10
Views: 6040

Re: Kit assembly questions

Your fan bracket looks great! Thanks. I'm guessing the two fans still only attach to the extruder via the one screw? The rubber sticky pad makes sense now. Thank you. There was actually some sticky residue in the spot you described. I'm guessing that's where that one pad came from that I found with ...
by KiddingMe
Wed Dec 31, 2014 3:00 am
Forum: Kit Assembly
Topic: Kit assembly questions
Replies: 10
Views: 6040

Re: Kit assembly questions

Thank you for the answers. After switching from my phone to my laptop I realized that my picture shows up way too large so I re-sized it and re-attached it. I'm still not to sure where the small, square, sticky rubber pads are meant to go. The printer all ready has very large, round pads that are se...
by KiddingMe
Wed Dec 31, 2014 12:57 am
Forum: Kit Assembly
Topic: Kit assembly questions
Replies: 10
Views: 6040

Kit assembly questions

Hello, Just a couple of questions. Even after tightening the printed Z-limit switch mount to the rod I can move it up and down or spin it fairly easily. Is this normal? I would think not. How do you correctly clock or position the extruded motor into its mounting bracket? I imagine you want the extr...