Search found 57 matches

by nokianich
Fri Jan 23, 2015 3:29 pm
Forum: Printed Object Showcase
Topic: Rose
Replies: 1
Views: 1485

Rose

Hello,

This is my print of rose taken from thingeverse. I used layer width of .35, ABS Dark Night (black) color... Can you explain me pls how printer will print .50 (that what was in properties in S3D) if nozzle is .35? and what is multiplier in S3D Layer Settings?
2.jpg
2.jpg (283.49 KiB) Viewed 1482 times
by nokianich
Wed Jan 21, 2015 6:24 am
Forum: Getting Started
Topic: Trouble getting started
Replies: 41
Views: 19421

Re: Trouble getting started

sorry, was busy for a while ) Yes the filament drive that holds the hot end. Look at it with the fans removed. Is that not straight as well or is the hit end just crooked in the mount? yes, that was twisted too. Today I was changing filament from PLA to ABS that got stuck and I had to disassemble Ho...
by nokianich
Fri Jan 16, 2015 12:50 pm
Forum: Getting Started
Topic: Trouble getting started
Replies: 41
Views: 19421

Re: Trouble getting started

jimc wrote: is the centerline of the filament drive on an angle or is the hot end crooked in the mount?
centerline of the filament drive
by nokianich
Fri Jan 16, 2015 1:15 am
Forum: Getting Started
Topic: Trouble getting started
Replies: 41
Views: 19421

Re: Trouble getting started

Odd---I've never heard of the connector getting in the way of the motor mount (but there have been multiple versions of the motor mount). Can you post a picture? It sounds more like something's not installed right more than anything else. While my first reaction is to tell you to get to the root of...
by nokianich
Thu Jan 15, 2015 5:50 pm
Forum: Getting Started
Topic: Trouble getting started
Replies: 41
Views: 19421

Re: Trouble getting started

loosen the motor mount, straighten it and retighten I can't, it's already turned all the way to the left and motor connector socket touches mount and doesn't let to twist it more Also check for cracks in the motor mount. It's possible that it was only a hard knock that shifted it, especially if the...
by nokianich
Thu Jan 15, 2015 3:28 am
Forum: Getting Started
Topic: Trouble getting started
Replies: 41
Views: 19421

Re: Trouble getting started

(1) The extruder is not straight in the motor mount. If it's twisted a little bit clockwise, then the nozzle will be a few mm off and end up on the plate during the purge cycle. Thanks for your answers. I just took a look and yes, it is twisted clockwise a little bit... is there any way to fix this?
by nokianich
Wed Jan 14, 2015 11:23 pm
Forum: Getting Started
Topic: Trouble getting started
Replies: 41
Views: 19421

Re: Trouble getting started

Hello everyone! I have a small problem, when I start printing my bed with nozzle heating up and then nozzle moves to right side of the bed and extrudes filament right on the edge of the bed, it happens on the left side too. Is it normal or what should i do? https://www.dropbox.com/s/zw79sx45kla317u/...