Search found 3136 matches

by Jules
Tue Mar 21, 2017 5:08 am
Forum: Printed Object Showcase
Topic: .25mm nozzle .1mm layers
Replies: 6
Views: 2851

Re: .25mm nozzle .1mm layers

Yeah, that'll work! :D
by Jules
Mon Mar 20, 2017 5:24 am
Forum: General Discussion
Topic: Minor design flaw on M2 Rev E.
Replies: 4
Views: 3075

Re: Minor design flaw on M2 Rev E.

Yes, it's written up in the Beginner's Guide. Just make sure you keep the clips running parallel to the long edge of the plate.
by Jules
Sun Mar 19, 2017 1:52 pm
Forum: Filament
Topic: Print Settings for PETG: eSUN Solid Black Filament
Replies: 182
Views: 531343

Re: Print Settings for PETG: eSUN Solid Black Filament

When you start a print, just use the tweezers to pull the glob down when it purges to the side. Makes for a neater print without the smear.

If you don't remove the glob with a wipe on the glass or by cleaning with the tweezers when you start a print, it winds up IN your print, which you don't want.
by Jules
Thu Mar 16, 2017 4:42 pm
Forum: Tech Support
Topic: Infill is killing me!
Replies: 10
Views: 5952

Re: Infill is killing me!

Wow! That's a pretty print! Nice job! :D

The setting you're looking for is on the Layer tab....Start Points - Use random Start Points for all Perimeters.
by Jules
Thu Mar 16, 2017 4:15 am
Forum: Tech Support
Topic: Possible bad Stainless Steel nozzles
Replies: 8
Views: 4240

Re: Possible bad Stainless Steel nozzles

You should be able to see a comparison of the size to the other nozzle if you clean them off, from the outside, but it doesn't matter. Support ticket is probably the way to go anyway.
by Jules
Thu Mar 16, 2017 3:44 am
Forum: Tech Support
Topic: Possible bad Stainless Steel nozzles
Replies: 8
Views: 4240

Re: Possible bad Stainless Steel nozzles

Might want to measure the hole with a calipers then - they might be out of spec.
by Jules
Thu Mar 16, 2017 2:43 am
Forum: Tech Support
Topic: Possible bad Stainless Steel nozzles
Replies: 8
Views: 4240

Re: Possible bad Stainless Steel nozzles

Did you check the size stamped on the side of the nozzles? (Might have accidentally gotten a 0.5 mm nozzle or two.)
by Jules
Tue Mar 14, 2017 7:07 pm
Forum: M2 Dual Extruder
Topic: Can support increase accuracy/definition of small features?
Replies: 19
Views: 12629

Re: Can support increase accuracy/definition of small featur

The shape of those makes it impossible to do what I would have suggested, which would be to pause the print and print the text raised on the design in a different color. If it were a horizontal top, you could maybe get away with it. But that canted angle makes it impossible. That would be a tough one.
by Jules
Mon Mar 13, 2017 6:51 am
Forum: Tech Support
Topic: Bottom and Perimeter Separation Problem
Replies: 7
Views: 3306

Re: Bottom and Perimeter Separation Problem

Looks like the layers are being under extruded a little bit - there are pretty distinct lines between your threads, and you can see the layer below. Check your extrusion multiplier, make sure you have the gap set correctly, and make sure that you have enough Outline Overlap on your Infill (about 15%...