Search found 90 matches

by sonra
Thu Oct 29, 2015 6:07 pm
Forum: Tech Support
Topic: Glass plate breaked
Replies: 2
Views: 1088

Re: Glass plate breaked

Hi
Thanks for help
by sonra
Wed Oct 28, 2015 6:03 pm
Forum: Tech Support
Topic: Glass plate breaked
Replies: 2
Views: 1088

Glass plate breaked

Hi guys ,
I succeed to break the plate , I wonder if I can replace it with simple glass plate I order from glazier or it is in any way special . Is it better to stick with glass or replace it with other material plate like aluminum ???
Regards Doron
by sonra
Sat Sep 12, 2015 9:41 pm
Forum: Getting Started
Topic: problem during few hours project
Replies: 2
Views: 1970

Re: problem during few hours project

Hi
Thanks . Will give at try
'
by sonra
Sat Sep 12, 2015 6:30 pm
Forum: Getting Started
Topic: end of filament in middle of print
Replies: 4
Views: 2761

Re: end of filament in middle of print

Thanks for help . I wish next printers will have sensor that stop the print in case filament is ended in middle of print ( to my knowledge in electronic it is not very big problem )
by sonra
Sat Sep 12, 2015 5:30 pm
Forum: Getting Started
Topic: end of filament in middle of print
Replies: 4
Views: 2761

Re: end of filament in middle of print

Hi
Thanks for response, It i way to solve the problem if you can check for time to time but if you want to leave the printer over night it will not help much
by sonra
Sat Sep 12, 2015 5:27 pm
Forum: Getting Started
Topic: problem during few hours project
Replies: 2
Views: 1970

problem during few hours project

Hi Try to print" GrumpyCatWithHolesForSignOnPlate" it is a model that takes about 3 hours in middle the output from the extruder begin to curly and of course all print has to be stop and go to garbage . i use Simplify the filament is Hatchbox pla . the bed is heated to 60 degrees Cel. and extruder t...
by sonra
Sat Sep 12, 2015 12:49 pm
Forum: Getting Started
Topic: end of filament in middle of print
Replies: 4
Views: 2761

end of filament in middle of print

Hi guys,
I am using Simplify to control my M2 . is there any way how to avoid the situation that the roll is finished and the printer keeps on print
I mean in long time prints that you are not near the printer and can pause
by sonra
Fri Aug 28, 2015 3:01 pm
Forum: How-to/Guides/Tips
Topic: bed leveling
Replies: 1
Views: 1410

bed leveling

Hi guys
I bought a second hand printer and it need a bed leveling. Is there any place with written process how to do do it , because what i found are some movies on YouTube and my hearing sense is a bad so it does not help me much
by sonra
Thu Aug 27, 2015 8:11 pm
Forum: Tech Support
Topic: hat bed does not work
Replies: 2
Views: 939

Re: hat bed does not work

Hi
Thanks for help
the problem was the unplugged connector on the wire from the control box to the heat bed
by sonra
Sat Aug 22, 2015 4:43 pm
Forum: Tech Support
Topic: hat bed does not work
Replies: 2
Views: 939

hat bed does not work

Hi guys
I bought a second hand M2 printer pre assembled and start to learn how to use it . I try the motors and extrude and they work but the bed heat does not work any idea what can check from electric side ??