This is kind of strange. Had to go to 280 go get this stuff to flow . Don't seem right to me.. Sent email to the distributor to ask if .25 is just too small but seems like at 260 the hot end cools off after 30mm extuded in a row and then has to heat up for a bit before a little more will go.. tied p...

Phil wrote:I have not made any tension changes.

Ok great! If I raise the temp and it still strips out I guess I need to install a larger nozzle..

I have not used ePA, but I print several other nylons, all at about 265C. Have you tried a higher temperature? No, as once I got the drive back together I called it a night. Will try that tonight.. esun temp listing is 240-260 but will try 265 tonight.. What about tension.. any tips.. less or more ...

Hey just tired to use some eSun EPA in my M2 with at .25 nozzle after using abs with no issues. Had nozzle at 250 and loaded it up and as it extruded it would eventually stop after 30 mm or so and strip out. I eventually ended up with it all wrapped around the the filament drive and had to take it a...

Anyone have any cool LED mods for the M2? Maybe like some LED spotlights on the print area? Hello jdlev, I also have the same query. Can anyone give the proper solution to it? Every response will be appreciated.......!! Thanks. Just finished doing headlights.. see this thread http://forum.makergear...

Wanted more light on the part so I installed a couple of LED on the back of the bed fan. I also removed the finger guards from both fans to reduce the noise and move more air. Parts List is: 2 NTE30045 White LEDs (local Micro center) 1 560 ohm resistor Arduino male and female headers 2 pins worth of...

I am about 4 days ahead of you.. I had my white PLA out using it for a few day in about 50% humidity before doing the simple string test model I found online and I has some fin strings.. Cranked the retraction speed way up and was better. I then ordered a Presto Food dehydrator and ran the pla in it...

When you're tuning slicer settings, change one thing at a time and keep track of what you're doing. Changing All The Things generally produces awful results, leaves you with a broken configuration, and wastes far more time than a systematic (pronounced "boring") exploration of the possibilities. (*...

So I have about 2 dozen solid calibration squares. I'm about burnt out of ideas on what setting to change. Tried wipe with different lengths, Coast with different lengths, single extrude endpoint extension distance, retraction speed, force retraction on layer change, direction inside out and outside...

what did you print this with, PLA or something else?