Search found 277 matches
- Fri Oct 02, 2015 4:11 pm
- Forum: Getting Started
- Topic: Initial Problems
- Replies: 31
- Views: 34630
Re: Initial Problems
Thank you, greatly appreciated.
- Fri Oct 02, 2015 4:11 pm
- Forum: Getting Started
- Topic: Initial Problems
- Replies: 31
- Views: 34630
Re: Initial Problems
Also in this video its running from the gcode on the sd card. I'm under the impression that my FFF would have no impact on something that is already gcoded.
- Fri Oct 02, 2015 4:05 pm
- Forum: Getting Started
- Topic: Initial Problems
- Replies: 31
- Views: 34630
Re: Initial Problems
This is a video of what the machine is doing.
- Fri Oct 02, 2015 3:51 pm
- Forum: Getting Started
- Topic: Initial Problems
- Replies: 31
- Views: 34630
- Fri Oct 02, 2015 3:28 pm
- Forum: Getting Started
- Topic: Initial Problems
- Replies: 31
- Views: 34630
Re: Initial Problems
Appreciate the response. I am still lost. Starting over today. So the first thing I wanted to do was try the gcode files on the MG provided SD card. The tallthin prints good. It does have the vertical stop/start point that goes from the bottom to the top. Another user here had the exact same experie...
- Fri Oct 02, 2015 7:28 am
- Forum: Getting Started
- Topic: Initial Problems
- Replies: 31
- Views: 34630
Re: Initial Problems
Thanks Jules, I am going to keep trying and see what I can figure out. I keep trying to print different things, but going to focus on one item and see what changes I can make that will make improvements. Going to try the Z-Offset, and see where it gets me. The one thing note worthy at least to me, i...
- Fri Oct 02, 2015 5:41 am
- Forum: Getting Started
- Topic: Initial Problems
- Replies: 31
- Views: 34630
Initial Problems
Hi all, just wanted to start by saying I really have tried, searched, tweeked, and still can't figure this one out. My nozzle will not print close enough to the glass. Even though I have done the Z-Stop and its less than a business card, still when it goes to print it move up about 10-20mm from the ...