Search found 74 matches
- Sun Aug 23, 2015 1:40 am
- Forum: Getting Started
- Topic: Just got my printer -- Motors will not work
- Replies: 18
- Views: 20921
Re: Just got my printer -- Motors will not work
Attempting connection at /dev/cu.usbmodem1411... Also, is this the right device? On my computer (Linux), if I unplug the USB, it switches to /dev/ttyUSB0, which is some default but not what my printer uses, and if I then plug the USB back in, it stays on that (wrong) setting until I manually select...
- Sun Aug 23, 2015 1:32 am
- Forum: Getting Started
- Topic: Just got my printer -- Motors will not work
- Replies: 18
- Views: 20921
Re: Just got my printer -- Motors will not work
Yes, it is set to the right numberjsc wrote:Is your baud rate set to 115200? If not, it should be.
- Sat Aug 22, 2015 11:21 pm
- Forum: Getting Started
- Topic: Just got my printer -- Motors will not work
- Replies: 18
- Views: 20921
Re: Just got my printer -- Motors will not work
To elaborate, when I turn the power on, Simplify3D automatically detects it and tries to connect: Attempting connection at /dev/cu.usbmodem1411... Testing plaintext communication protocol... Testing binary communication protocol... Testing alternate communication protocols... Attempting RTS reset an...
- Sat Aug 22, 2015 11:19 pm
- Forum: Getting Started
- Topic: Just got my printer -- Motors will not work
- Replies: 18
- Views: 20921
Just got my printer -- Motors will not work
I just upgraded to the M2. I was a pro with my old printer (Up! plus, or affinia here in the states), and now feel I have to learn to walk from scratch. Got the box today, and went through all the unpacking instructions checking each step. I did get the printer on and connected with Simplify3D. Test...