Thanks Jules! Update: this is working a lot better with proper Z-Height, lower temps and hairspray. I'd been resisting hairspray because I was afraid it might be messy, but it makes a world of a difference. For those who encounter similar problems with PLA, here are my notes. Nothing here is earth s...

Thanks Jules! I think I haven't yet gotten the Z-Height perfect so I'm trying to nail it first and then move on to looking at things like temperature and adhesives. I've been printing some of the calibration squares suggested on other threads, to try to really nail the Z-height (I assume this is sti...

I've been having some printing issues and I'm not sure what the cause is. Prints tend to be bulgy and the first layer seems to be missing some material in certain regions (I think it's might be peeling over, but it's hard to tell). Is this a temperature issue? Not getting the Z-Height quite right? I...

Update: I was able to get this addressed by setting the Z-Height with Josh's Z-Adjust Tool <http://forum.makergear.com/viewtopic.php?f=10&t=3072&hilit=Josh&start=220>. I'm certain that I was clicking "Save Starting Height" in the Quickstart tool when I was having trouble with it earlier. Support als...

I sent support a note and included a link to this as well as description of the issues.

Thanks Jules, that was super helpful! I actually am new to 3D printing, though I've read a lot online and have some experience dealing with complex software and mechanical systems. I'll write support about the firmware. I do find it a little bit odd that it seems like it accepted the correct startin...

I'm having a similar problem. I have a 1 day old Rev E and I'm having a hard a time getting the starting height calibration information to save correctly when I press the "Save Starting Height" button in the "Getting Started" application. I've been very careful to always make sure the height on the ...