Search found 667 matches
- Sat Apr 02, 2016 2:21 am
- Forum: Tech Support
- Topic: Inter-layer adhesion issue
- Replies: 48
- Views: 43021
Re: Inter-layer adhesion issue
Black pla from ebay. Cheap chinese stuff I found that prints great.
- Sat Apr 02, 2016 2:02 am
- Forum: Modifications
- Topic: New Extruder Drive Gear
- Replies: 59
- Views: 75676
Re: New Extruder Drive Gear
This will drop in to what you are already using with no issues.
- Fri Apr 01, 2016 12:51 pm
- Forum: Filament
- Topic: Feed Failures with PETG
- Replies: 33
- Views: 38685
Re: Feed Failures with PETG
Print at 1800 mm and at 255 or 260 .I run my filament tension very tight. I would rather see the filament doubled over itself than have the half circle cut out of it. In either case when you see either of those issues it is...at least in my experience caused by trying to print to fast. The v4 never ...
- Thu Mar 31, 2016 5:38 pm
- Forum: Filament
- Topic: Feed Failures with PETG
- Replies: 33
- Views: 38685
Re: Feed Failures with PETG
If the filament doubled over itself. Then you are trying to print it to fast.
- Thu Mar 31, 2016 5:35 pm
- Forum: Tech Support
- Topic: Z-stop light still on at layer 3
- Replies: 5
- Views: 7798
Re: Z-stop light still on at layer 3
You need to set your z off set to zero. Z off set is for advanced users. You set the z stop with the bolt. So that the bed homes to the correct z gap below the nozzle. You home the machine and slide your feeler gauge between the end of the printers nozzle and the heated bed. Adjust bolt so bed stops...
- Thu Mar 31, 2016 3:00 pm
- Forum: Filament
- Topic: Any heat resistant Plastics for GPS bracket in a boat?
- Replies: 31
- Views: 45532
Re: Any heat resistant Plastics for GPS bracket in a boat?
Unless like in my new house they are white pvc....lol
- Thu Mar 31, 2016 2:53 pm
- Forum: Tech Support
- Topic: Inter-layer adhesion issue
- Replies: 48
- Views: 43021
Re: Inter-layer adhesion issue
This was a year old roll of matterhackers pro pla. I will run a few of these with a couple of other brands to see. I suspect different colors and or brands might behave differently.
- Thu Mar 31, 2016 1:01 pm
- Forum: Tech Support
- Topic: Inter-layer adhesion issue
- Replies: 48
- Views: 43021
Re: Inter-layer adhesion issue
Shinier as temp goes up. Hard to tell by these photos though.
- Thu Mar 31, 2016 12:02 pm
- Forum: Tech Support
- Topic: Inter-layer adhesion issue
- Replies: 48
- Views: 43021
Re: Inter-layer adhesion issue
Until you get.your z off set ...layer height ....and bed level spot on ....no amount of advice will help.
- Thu Mar 31, 2016 1:09 am
- Forum: Tech Support
- Topic: Inter-layer adhesion issue
- Replies: 48
- Views: 43021
Re: Inter-layer adhesion issue
Printing a temp block in pla now...as it has been a while since I have printed any pla... My memory might be backwards... 180 was a no go at all with this roll of pla. It will start at 190 and go to 220. Will post results when done.