Here's what I'm working on. Wanted a cabinet I could also put my vinyl cutter in (that will be a lower section). it's an old entertainment cabinet I picked up at a Habitat store for around $45. The compartment on the upper right is for filament, slide out bottom shelf for 6 rolls, top I'm going to h...

Here's one I'm working on. Wanted a cabinet I could also put my vinyl cutter in (that will be a lower section). it's an old entertainment cabinet I picked up at a Habitat store for around $45. The compartment on the upper right is for filament, slide out bottom shelf for 6 rolls, top I'm going to ha...

Haven't used my printer since having to replace the Rambo board. When I did, I also added the Dual upgrade, and bottom Z-Stop and I have the Silver (older style) z-stop motor. . Bit confused on which firmware I should be using. I see a firmware for a system upgraded with 4 point leveling and z-stop ...

Filter for exhaust (or intake) fan? Anyone using a filter, with an enclosure, on the exhaust air, or intake air? Was looking at different filter options and ran across a small, about 1.5 inches thick, car filter clearanced for $4, Anyone think one of these would work? Thinking it may be a bit restri...

Do I need to set my bed heat higher, or just give it more time to heat up?

Anyone relocated the Rambo board outside the printer base? Had to replace my Rambo board and building an enclosure, thinking I could add wire and relocate it outside the enclosure. Anyone think of any concerns issue this would cause?

If this is double I'll delete, thought I sent from phone. Setup a print before bed one night. Checked early morning and the nozzle was broken off hanging. May have been me zeroing. had ordered the parts to upgrade to RevE, It had blown fuse so I ordered some and all was well. Took it offline to upgr...

I'll take one

Couldn't you use blind rivet nuts for this?

I did use supports. Just removed them before the photos. The one with "the arms sticking out" (didn't noticed that it looked like that until mention I see that now Ha Ha), was a button also.