Hi
I found the problem .The sensor tip when in push position ( down ) was a little above the extruder , so the table when try to go to home position crushed into the extruder and not the sensor . Now i put spacer so the sensor tip is below the extruder and G28 and G29 do the job

Hi guys The sensor response to manual commands M280 P0 S10 ; pushes the pin down M280 P0 S90 ; pulls the pin up M280 P0 S120 ; Self test –keeps going until you do pin up/down or release alarm M280 P0 S160 ; Release alarm send M500 to store in EEPROM and m502 when i send G28 . The bed move x and y ho...

THANKS

Hi
What I mean to ask how/where those springs are attached to the BlTouch . I don't see them in doc supplied with unit or in any installation doc
Doron

Hi
i got with the BLTouch kit 2 springs . are they in use in M2 ?
Doron

Thanks for classification
Doron

Hi guys I am a new player in the M2 modifications field .i use the metal aluminum MIC6 plate as print plate . I got the the BLTouch sensor in hope to got a better result in leveling the plate ( I try to use the screws ) I don't understand hoe to connect the three wires cable to the Rambo because jtu...

hi guys I read about the option to replace the glass glass with aluminum . is the aluminum should be from any type of material ? ( as i know there are many kind of aluminum type ) i also that Insta is selling plates that is coated with PEI . Is it better and does the coat has to be renew after print...

Hi guys,
Did nay one have used the BQ pla filament ?
regards Doron

Hi
Thanks for help will try it