Mine did that too after accidentally colliding with one of the binder clips. I used a couple of zip ties to cinch it down so I could print a new one, but you have to really pull them tight with pliers. It worked long enough to print two new mounts and was still tight when I replaced it.

I am SO jealous! I have been looking for a way to cost-justify getting another (or multiple) printers but so far, it is elusive. I hope to join the "multiple" club soon…

In the meantime, I guess I can live vicariously!

At least now I'll know where to look if it acts up again.

And I meant Jim, not Insta! All you multi-machine guys blur after a while when seen through jealous eyes

So, the mystery deepens. I did as Insta suggested and unplugged the Z motor. I was then able to jog X and Y, and when I jogged Z, nothing happened (of course with the motor unplugged). I was able to continue jogging the X and Y. I plugged the Z motor back in and before messing with the firmware agai...

Last night my printer was working perfectly in the Quick Start app for the new leveling system and I had done the setup multiple times with no issues. I haven't actually printed anything since doing the conversion last week. Tonight I go to fire it up, and anything involving a Z jog input or home al...

Speaking of which, I've noticed that the build platform seems to lose its level rather quicker than I expected. I've noticed that after a few hours of print time if I check the level, it is no longer true. I don't really know what the acceptable amount of unevenness is yet, but the bed is noticeabl...

I just realized that the Quick Start App might be considered as part of the new system, so I hope posting screen shots of some of the pages didn't go against Rick's "no photos" request. I assumed that only applied to the hardware. If not, I will delete them or an admin can do so. Jim, I'm also runni...

I should clarify it's jumbled and also cut off in some instances.

I have some observations and a question about S3D. Overall the upgrade was painless and the bed is SO MUCH easier to level. It takes all the mental gymnastics out of it. The hardware installation went smooth and the instructions were very clear. The only trouble I had was when attaching the spider t...

It's been a while since I installed an E3D, but I seem to remember having the instructions say to bring it up to full operating temperature and then tighten the nozzle a bit more. I've never had a leak. Also, you mentioned you were part way through a print and the printer dinged that it was done - i...