Search found 14 matches
- Wed Jul 22, 2015 2:36 am
- Forum: Getting Started
- Topic: loving my printer but need help with two things...
- Replies: 13
- Views: 15350
Re: loving my printer but need help with two things...
I think i'm just being overly paranoid with the fan, i left it alone on a print and it would turn on when I assume it felt it was needed. I ended up with the plastic splitting which i'm not sure was a issue due to the extruder temp or needing more cooling. As far as the Z stop, it's the opposite end...
- Tue Jul 21, 2015 8:07 pm
- Forum: Getting Started
- Topic: loving my printer but need help with two things...
- Replies: 13
- Views: 15350
Re: loving my printer but need help with two things...
kit. double checked all the connects. if i wiggle the harness with the z stop it will light up.
still having fan issues. it goes fine til about halfway through the print then turns off and i manually have to turn it back on with commands.
still having fan issues. it goes fine til about halfway through the print then turns off and i manually have to turn it back on with commands.
- Tue Jul 21, 2015 4:48 pm
- Forum: Getting Started
- Topic: loving my printer but need help with two things...
- Replies: 13
- Views: 15350
Re: loving my printer but need help with two things...
okay so the fan should be running the whole time, where would I look to see why it's not? sorry, the whole gcode side is new to me. As for the light it turns on mid print. if I tap the electronics case it turns on, so it's looking like its a short in the wire. It came on during a print last night bu...
- Tue Jul 21, 2015 4:34 pm
- Forum: Getting Started
- Topic: loving my printer but need help with two things...
- Replies: 13
- Views: 15350
loving my printer but need help with two things...
I managed to get it up and running; getting a pretty decent print at .2 and I can't wait to see what it can do when I get better at using it! first issue is more of a question; I had seen that the 50mm fan should always be running; is this the case? mine runs intermittent and I kept manually turning...