Metal extruder mount
http://www.makergear.com/products/metal-motor-mount

I didn't do it. I had my sisters boyfriend do it. He is a in training electrician....

Ok I have figured it out.... Took apart my outlet to find that the ground wire was not hooked up. Go figure....

Just checked with my other laptop and also my raspberry pi. My other laptop i'm seeing a voltage again. The raspberry pi i'm not seeing a voltage but the arm test i'm still getting shocked. I may need to contact a electrician. But I do have one concern. With using the metal rambo case the rambo is i...

My laptop only has a 2 plug. I have another laptop that I'm going to hook up later and see if I have the same problem. I did try multiple outlets and all are doing the same thing.

Ok the plot thickens. When I print my laptop is plugged into the wall. If I unplug the laptop from the wall the voltage disappears.

Do you have a multimeter handy? I checked on the pulley and a screw on the top of the power supply. Its definitely a constant voltage.

I'm really confused about this. I have triple checked everything and I can't find it.

Hopefully someone might know what's going on. I know the new electronics case the rambo is installed down with 4 metal 4-40 screws.

I have checked all my connections and I don't see anything wrong.