Hi Rick, I have not upgraded 24-volt yet. I'm actually just getting back into 3d printing after a long hiatus. If I get some time this weekend, I'll try to snap some photos of the wiring harness. I'll probably be in the market for a dual-extruder if they become available again.
Thanks,
Dave
Search found 23 matches
- Wed Jul 08, 2015 8:48 pm
- Forum: General Discussion
- Topic: Early M2 how to open the electronics case?
- Replies: 8
- Views: 7621
- Wed Jul 08, 2015 7:25 pm
- Forum: General Discussion
- Topic: Early M2 how to open the electronics case?
- Replies: 8
- Views: 7621
Early M2 how to open the electronics case?
I have a very early M2, and I'm trying to verify that I have the version with the safety recall issue, but I can't seem to get the acrylic enclosure open. Is the enclosure glued shut? I'd hate to snap the cover into pieces if there's a way to release it without breaking it.
Dave
Dave
- Tue Jun 30, 2015 2:56 am
- Forum: Tech Support
- Topic: Y Axis Printing at an Angle
- Replies: 23
- Views: 24495
Re: Y Axis Printing at an Angle
Heya Insta... long time no see.
Just a thought, but does the firmware support saving a transform matrix to compensate for an un-level bed? Perhaps, the firmware was set to compensate for an un-level bed, and is still applying the compensation even though the bed is now level?
Dave
Just a thought, but does the firmware support saving a transform matrix to compensate for an un-level bed? Perhaps, the firmware was set to compensate for an un-level bed, and is still applying the compensation even though the bed is now level?
Dave