Hello Jk! Actually, I'm not getting any diagnostics/errors sine I'm printing from SD card and I don't have a display yet. So, I really don't know whats going on. I could start a print via usb in order to get that diagnostic. Anyway I'm getting the idea that it's something related to the extruder tem...

Anyway Ed, the other question would be... Why this sudenly might started? 2-3 days ago I wasn't having an issue like this. Should be something related to the thermal sensor or the wire on the bed? I'm checking those but I can't seem to find any issue with them (I move and pull them in order to detec...

Thanks Ed. I'm modifying the values on my firmware... Anyway I don't have all those variables you've mentioned. I only have these ones: #ifdef BED_LIMIT_SWITCHING #define BED_HYSTERESIS 6 //only disable heating if T>target+BED_HYSTERESIS and enable heating if T>target-BED_HYSTERESIS #endif #define B...

I have an issue that it's causing me headaches! I've been printing PETG parts with success until a few days ago. It seems that the program is stopped after a couple of hours of printing and apparently "stops" completely, because when I reach the printer, the nozzle is stucked in the part... nozzle c...

@Ed, thanks a lot for your explanation!

I'll follow your links and contact MG support in order to make this upgrade immediatelly. Thank you very much again!

Amazing! Both of you! Thanks a lot! Well, I wasn't that worried since I'm still printing, and as I said, it seems to be something that happens rarely. @Ednisley, I do have an old Z motor (black-silver) so I guess that should be one problem, even though I'm printing parts that I already printed, MANY...

Hello to all! Well, I had this issue two or three times already... The table is falling down (-Z) in a middle of a print, but the print continues... therefore the nozzle continues delivering plastic to the air... the table completely down, forming a nest of plastic above the table. I couldn't see if...

Great! Let me find out how to deliver it to Brazil. I'll PM you once I find out. Thanks a lot!

Or, buy a Viki1 from me ;) hahahaha I guess that I'm reading that phrase from you since 2013 !!! hahahaha I thought that during these last 4 years someone could actually install one of those! I don't know what will I do with that beautiful Viki2! I guess they focused on beauty but not on compatibil...

Hello, good morning! This is an old subject and for what I could read, maybe unresolved? It happens that I bought an VIKI2 and after that I read that it might be uncompatible with my M2!!!! Anyway, now I'm fighting to install it: I was folowing the instructions from VIKI itself and from your Wiki, b...