Thanks.

It leveled and calibration went well.

First print running now. Wont know anything for sure until morning but looking good so far.

Thanks for the help.

When you level the bed run all the leveling screws all the way in. Then back each out about 1/4 turn. Then adjust by backing out only 2 of them. With the screws close to bottom out they hold better. I usually only adjust once per year.

Well thought I would try The PEI Sheet. I think it assembled ok . Little bit tricky but followed the hints from the forum and
finally got it on.

Tim when you print does it use this pattern of offset for the entire build or just the first layer.

Insta. Flip the plate 180 degrees. See if the problem moves to the other end. If it does the problem is in your plate. If there is a problem with the plate try the other side and see if the problem is there as well. I am guessing the problem is with the blasted side if it is it may be over blasted i...

At least you were not playing with your explosives with a wiring incident.

I think the foil would do a better job of stopping aliens from monitoring my prints.
Dont know how much faster it would really be.

I am jealous. Would love to be able to swing by.

Have a good time.

That does seem a bit excessive. It may have been bent. I have heard where one side is better than the other.

I have been following the auto leveling with much interest. This is getting really cool. I have some questions and concerns over the auto leveling both the Mesh and plane styles. I use my machine for some manufacturing prototyping where accuracy of the print is the key. I will typically print an ite...