Search found 43 matches
- Mon Jun 27, 2016 4:22 am
- Forum: Getting Started
- Topic: Higher definition, higher warp?
- Replies: 3
- Views: 7405
Re: Higher definition, higher warp?
Thanks for those answers! I made sure my first layer was at least 0.250 mm in both cases by increasing the percentage for the percentage. I did not reduce the extrusion width though. The point about the nozzle tip makes sense physically. I was going according to what I understood from the Beginner G...
- Sun Jun 26, 2016 5:18 am
- Forum: Getting Started
- Topic: Higher definition, higher warp?
- Replies: 3
- Views: 7405
Higher definition, higher warp?
Hello, I just began using my M2 Rev.E. After printing the bracelet, my first project is the Gear Cube available on thingyverse. I figured since it has a lot of similar parts, I would be able to print each one of them separately and play with S3D's setting in order to learn. I had to use a large Brim...
- Sun Jun 26, 2016 4:59 am
- Forum: Getting Started
- Topic: Quick Start - 2mm hex wrench step not available?
- Replies: 6
- Views: 13143
Quick Start - 2mm hex wrench step not available?
Hello, I just received my M2 Rev.E and I am really pleased with it so far. I ran into some trouble doing through the Quick Start App tough. First time I did all the steps, when the printer started, the nozzle was too low and crashed into the plate after it purged some filament. Second time I ran the...