I reset the Z-endstop and G-code and re-balanced the plate. Now I am back to square one and the print smashes all over the plate when I tried to cal. I swear to you I am doing everything right as far as procedural goes and I am taking my time to do this. It might be worth noting that the left side o...

Are you talking about the Z-end stop gap or the Z-offset adjustment?

OK, I found the exact center of the plate and set the Z-end stop to .15MM. I then balanced the bed and was able to perform a successful cal to set the z-axis offset. I needed to make a 0.06mm adjustment. I re-caled and it was fine. The print appeared to be even, and then I tried to print one of my f...

It is PLA from Makergear.

So how do I set my Z-endstop to get back to printing? Why would a Z-endstop change cause the filament to no loner adhere and curl around the nozzle.

I have previously, but I am unable to do that now since I changed my Z-end stop. The Z-end stop is the only change I made so I am not sure why I cannot print now.

Out of the box the unit printed fine. A year later I did a end stop cal and a bed leveling and 50 times later I cant print anything.

This has nothing to do witht he PLA not sticking to the bed because of the bed, it has to do with my Z end stop.

I cant even get to a cal. I did try glue, no improvement.

Yes, I have read and re-read that thread and every other beginners guide available. I have set my Z End Stop gap from a sheet of paper, all the way up to .20mm with a feeler gauge. I have played with the offset in both directions .05mm at a time with no changes in results. I must be doing this wrong...

Greetings, I've set my Z End Stop and leveled my bed about 50 times in the past two days. I have used every different method described on this forum (getting started,etc), on youtube, and the methods used by MakerGear. None of them are working. The filament just curls around the hot end and nothing ...

Greetings, M2 V3B & Simplify3D PLA with heated bed to 70C For the last two days I have calibrated my Z-End Stop and leveled my bed about 50 times. I have used every method I could find on this site, youtube videos, and the MakerGear guides, but I cannot get a print out of this machine. Every time I ...