Search found 667 matches
- Thu Mar 31, 2016 1:03 am
- Forum: Filament
- Topic: Any heat resistant Plastics for GPS bracket in a boat?
- Replies: 31
- Views: 45601
Re: Any heat resistant Plastics for GPS bracket in a boat?
Your welcome !
- Thu Mar 31, 2016 1:03 am
- Forum: Modifications
- Topic: Mic 6 tooling plate
- Replies: 212
- Views: 351050
Re: Mic 6 tooling plate
Dang !!! nice work !!! It looks awesome !!
- Thu Mar 31, 2016 1:02 am
- Forum: General Discussion
- Topic: Raspberry Pi 3
- Replies: 65
- Views: 86423
Re: Raspberry Pi 3
Awesome !!! Glad to hear it !!!sthone wrote:Thanks seems to be working fine so far... the hive is a buzzing....
- Thu Mar 31, 2016 12:39 am
- Forum: Modifications
- Topic: Mic 6 tooling plate
- Replies: 212
- Views: 351050
Re: Mic 6 tooling plate
He`s all fancy with them now !!! lol Very nice Jim !!! I was thinking I need to get another to swap in and out as well.
- Thu Mar 31, 2016 12:37 am
- Forum: Filament
- Topic: Any heat resistant Plastics for GPS bracket in a boat?
- Replies: 31
- Views: 45601
Re: Any heat resistant Plastics for GPS bracket in a boat?
petg epc should be fine
- Wed Mar 30, 2016 11:35 pm
- Forum: Filament
- Topic: Any heat resistant Plastics for GPS bracket in a boat?
- Replies: 31
- Views: 45601
Re: Any heat resistant Plastics for GPS bracket in a boat?
Assuming sunlight as the heat source. Petg or epc. You are.not mounting.your GPS in the engine compartment ? Lol
- Wed Mar 30, 2016 11:33 pm
- Forum: Modifications
- Topic: Mic 6 tooling plate
- Replies: 212
- Views: 351050
Re: Mic 6 tooling plate
They are on thingiverse in the m2 group under things.
- Wed Mar 30, 2016 8:29 pm
- Forum: Tech Support
- Topic: Inter-layer adhesion issue
- Replies: 48
- Views: 43052
Re: Inter-layer adhesion issue
You are printing pla too hot. Usually....at least all the rolls I have had I print right at 180 or 190. Period. Filaments usually get shinier the higher you go in temperature and remain more matte or flat with lower temps. You might try printingredients instead of calibration cubes...just a one or t...
- Wed Mar 30, 2016 8:19 pm
- Forum: Tech Support
- Topic: V4 clogged nozzle - where can I find spares?
- Replies: 7
- Views: 8717
Re: V4 clogged nozzle - where can I find spares?
I am guessing...from a source of some practical experience...having ran .25 nozzles with other specialty filaments that it may not be possible to print that filament with a .25. I assume you already tried slowing your print speed down and upping nozzle temperature ? Some manufacturers flatly state y...
- Wed Mar 30, 2016 5:06 pm
- Forum: Modifications
- Topic: New Extruder Drive Gear
- Replies: 59
- Views: 75727
Re: New Extruder Drive Gear
It will not change the banding. Your z.and.bed level plus.extrusion calibration all impact that.