Search found 30 matches
Re: Nylon
Thank you, I will print with bed heated all the way and reset the others. I do not have an enclosure for I but will pre-heat bed then print. I have Simplify3D and need to adjust some settings then. Any other hints would be great, Thanks
Re: Nylon
I am making parts and would like to know How many layers I should have my bed temp @ 80c, my hot end is at 255 and a slower prints speed. The part is tall and about 1/8 inch thick. I get worping and the part break in layers easy. Any help please.
Re: Nylon
I have a part that I want to make and its just over 1/8 thick walls that make it up. Here is a pic not sure you can see what's going.
- Sun Dec 02, 2018 2:47 am
- Forum: Tech Support
- Topic: Feed motor
- Replies: 2
- Views: 4176
Re: Feed motor
Thanks, I forgot about that, its working fine now
- Sat Dec 01, 2018 1:56 am
- Forum: Tech Support
- Topic: Feed motor
- Replies: 2
- Views: 4176
Feed motor
I was changing filament and when I tried to start it, it would not feed. I found a piece of the old filament and then tried it again. The motor would not run. Is their a fuse somewhere that I need to change?
Thanks
Thanks
Re: Nylon
I am making a part that I need strength, flexibility and has weather resistance. I will send a picture of what I did last night but it started to warp so I stopped it.
I hope you can see them, and not the best at it.Re: Nylon
oh yes I also put a raft on this one
Re: Nylon
Yes electric stove and using Simplify 3D slow print rate but not sure of layer height its printing now and very slow rate. Not sure what setting I have but still trying. When I get some layers I will snap a picture, and send it. I did the 5 hours today in the oven but think I forgot to reset temp, n...
- Wed Nov 28, 2018 1:07 pm
- Forum: Filament
- Topic: side skirt
- Replies: 2
- Views: 15377
side skirt
I want to put on a side-skirt to help hold down my part when printing. How do I do that? I have a M2
Re: Nylon
Thank you so much, I did try again today to print, I put the roll in the oven for 4 hours at 170 degrees. I could not get it to stick on the corners.. The part is about 1/8 inch or more wide and it wants to worp on the corners. I know I was not going to sell it but just need to get it right so I can...