Search found 18 matches
- Mon Oct 14, 2019 1:53 am
- Forum: Tech Support
- Topic: rev e dual z axis inverted
- Replies: 2
- Views: 4350
rev e dual z axis inverted
Guys, I just upgraded my M2 dual to the 4 screw spider bed. I followed all the instructions I could find. Upgraded the firmware to rev e (M2E-Production-SnNRd-V101 - Dual) and ran the calibration tool. The first thing I noticed was that the Z travel in the calibration tool is reversed, meaning when ...
- Mon Jan 04, 2016 12:45 am
- Forum: General Discussion
- Topic: Modified Ikea enclosure
- Replies: 55
- Views: 106271
Re: Modified Ikea enclosure
Thanks very much Dug.
- Sun Jan 03, 2016 5:42 pm
- Forum: General Discussion
- Topic: Modified Ikea enclosure
- Replies: 55
- Views: 106271
Re: Modified Ikea enclosure
Right, but if I did use a fan, I was hoping to get some advice.dsmith wrote:I didn't go with a fan, just leave the door open a couple of inches when printing with ABS so it does not get too hot in there. Works fine. I really like the clean look of the white cabinet with the fan on top though!
-Don
- Sun Jan 03, 2016 5:47 am
- Forum: General Discussion
- Topic: Modified Ikea enclosure
- Replies: 55
- Views: 106271
Re: Modified Ikea enclosure
I have two questions: First, is it best to configure the muffin fan to blow air in to the box or to suck air out? (and do I need a second air hole to counter the vacuum?) -This is a two part question - sorry for that. Second, would one of you that created your own grommet plugs mind sharing your des...
- Sat May 09, 2015 6:38 pm
- Forum: Tech Support
- Topic: X direction shift during printing
- Replies: 18
- Views: 20488
Re: X direction shift during printing
Thanks Jules. I don't have anything labeled acceleration in the speeds area. Is it referred to as something else? Screenshot attached.
- Sat May 09, 2015 5:44 pm
- Forum: Tech Support
- Topic: X direction shift during printing
- Replies: 18
- Views: 20488
Re: X direction shift during printing
How can I reduce the acceleration rate in S3D? I'm having a similar problem and have seen that suggested here, but don't see that setting. Also, I've got several areas that I can configure a retraction. Where is the best place in the settings for changing retraction between layers?
- Sat May 09, 2015 5:40 pm
- Forum: Tech Support
- Topic: Shift in print (Y direction)
- Replies: 11
- Views: 15261
Re: Shift in print (Y direction)
I'm experiencing the same y-axis shift near the end of long prints. Same place every time. What's the recommended way to turn acceleration down? I'm using Simplify3d.
- Thu Apr 30, 2015 7:38 pm
- Forum: General Discussion
- Topic: One Year with a MakerGear M2
- Replies: 10
- Views: 18657
Re: One Year with a MakerGear M2
Does anyone have the link to the printable replacement parts mentioned here? I'd love to have that before I need it.