Search found 277 matches

by 3dPrintingMD
Fri Oct 02, 2015 4:11 pm
Forum: Getting Started
Topic: Initial Problems
Replies: 31
Views: 34297

Re: Initial Problems

Thank you, greatly appreciated.
by 3dPrintingMD
Fri Oct 02, 2015 4:11 pm
Forum: Getting Started
Topic: Initial Problems
Replies: 31
Views: 34297

Re: Initial Problems

Also in this video its running from the gcode on the sd card. I'm under the impression that my FFF would have no impact on something that is already gcoded.
by 3dPrintingMD
Fri Oct 02, 2015 4:05 pm
Forum: Getting Started
Topic: Initial Problems
Replies: 31
Views: 34297

Re: Initial Problems

This is a video of what the machine is doing.
by 3dPrintingMD
Fri Oct 02, 2015 3:28 pm
Forum: Getting Started
Topic: Initial Problems
Replies: 31
Views: 34297

Re: Initial Problems

Appreciate the response. I am still lost. Starting over today. So the first thing I wanted to do was try the gcode files on the MG provided SD card. The tallthin prints good. It does have the vertical stop/start point that goes from the bottom to the top. Another user here had the exact same experie...
by 3dPrintingMD
Fri Oct 02, 2015 7:28 am
Forum: Getting Started
Topic: Initial Problems
Replies: 31
Views: 34297

Re: Initial Problems

Thanks Jules, I am going to keep trying and see what I can figure out. I keep trying to print different things, but going to focus on one item and see what changes I can make that will make improvements. Going to try the Z-Offset, and see where it gets me. The one thing note worthy at least to me, i...
by 3dPrintingMD
Fri Oct 02, 2015 5:41 am
Forum: Getting Started
Topic: Initial Problems
Replies: 31
Views: 34297

Initial Problems

Hi all, just wanted to start by saying I really have tried, searched, tweeked, and still can't figure this one out. My nozzle will not print close enough to the glass. Even though I have done the Z-Stop and its less than a business card, still when it goes to print it move up about 10-20mm from the ...