Came across another odd thing today while printing. See attached. Not having much luck with S3D at the moment. The fine ribs on the S3D print are warped. Feed up with results using S3D I jumped across too Cura and quickly setup a profile at 0.2 layer height trying to match setting as best I could. I...

Appreciate it ed and airscapes! I think I'm finally getting somewhere with my settings and prints. At least now my height is close to perfect, with enough bed adhesion to keep the part on the platform (or not warp). Now to sort out the x and y . Thanks again!

I'm hoping I havn't out worn my welcome here :) I need to ask a few more questions about calibration. I realise there are many forum topics on the subject but some seem quite old and most are on the M2. None seem to be helping really so I wanted to ask in brief if I am calibrating my machine correct...

Thank you ednisley and airscapes, I appreciate the comments, suggestions, etc. ednisey - the parts I was printing at the time were small 30 x 60 x 10 mm optic lighting enclosures in ABS, with a base and lid which snapped together. There had never been an issue before while I had my Zortrax's, so I h...

Is it possible to adjust horizontal movements / steps in firmware to achieve a more accurate print? I find X & Y differ. Not by a lot but enough to have customers come back to me and say a part is off. I am playing around with manually scaling the digital model, mentioned in another post here, which...

Hi Zemlin.... just wanted to say thanks for this! After spending weeks trying to calibrate materials, horizontal offsets, vertical offsets, etc, etc. in S3D and not having a lot of luck I recalled seeing your thread here. On a 25mm cube I was getting large enough differences in my x and y so horizon...

Hi everyone, after doing a bit of a search and not finding a solution I decided to post here. I find my WIFI connection to my M3 a little flakey at the best of times and would like to, if possible, use a SD card for transferring files to my M3 SE. As there is no built in SD card slot on the M3 SE I ...

Thanks very much to the both of you. I have removed the brass nozzle. I mostly print with ABS so soaked it in acetone over night. I didnt have a fine enough tool to push through the nozzle but cleaned it as best i could. I am now back up and printing with that nozzle and hotend, but still cant perfo...

Hi All, I have a M3 SE, one year old which has worked pretty well since purchase. Lately I have been having some issues with filament not coming through and the extruder motor 'clicking'. A cold pull procedure does not seem to be working, trying quite a few times without any luck - the extruder moto...