Search found 67 matches
- Mon Oct 17, 2016 1:28 pm
- Forum: General Discussion
- Topic: Ending script to lower bed and move it forward
- Replies: 2
- Views: 4540
Ending script to lower bed and move it forward
Rev. E new user here. I'm looking for some code at the end of a print to lower the bed and move it forward.
- Sat Oct 15, 2016 3:25 pm
- Forum: Modifications
- Topic: LCD Panel instructions
- Replies: 6
- Views: 10367
Re: LCD Panel instructions
Thanks Jules,
Seems to be very little out there on the LCD screen. I found this, which may be helpful to others:
https://www.scribd.com/doc/237971715/LC ... n-Firmware
Seems to be very little out there on the LCD screen. I found this, which may be helpful to others:
https://www.scribd.com/doc/237971715/LC ... n-Firmware
- Sat Oct 15, 2016 3:15 pm
- Forum: General Discussion
- Topic: Printing: USB vs SD Card behavior
- Replies: 1
- Views: 3459
Printing: USB vs SD Card behavior
Just a quick question about some behavior I see when printing from an SD card without the computer attached. I noticed that the x and y axes periodically go to the end stops and then continue printing. This doesn't happen when printing with S3D over USB. Is this normal? No ill effects observed, just...
- Fri Oct 14, 2016 1:34 pm
- Forum: Getting Started
- Topic: New filament testing
- Replies: 1
- Views: 5458
New filament testing
Any tips on a preferred method to test/determine the best settings for a new roll of filament? This looks intriguing:
http://www.thingiverse.com/thing:696093
I'm assuming the gcode would run fine. A nice 'one and done' test piece would be nice.
http://www.thingiverse.com/thing:696093
I'm assuming the gcode would run fine. A nice 'one and done' test piece would be nice.
- Thu Oct 13, 2016 7:34 pm
- Forum: Modifications
- Topic: LCD Panel instructions
- Replies: 6
- Views: 10367
LCD Panel instructions
I searched the forum and found the wiki for the makergear LCD add on, but don't see anything regarding instructions, etc. Does a user guide exist?
- Thu Oct 13, 2016 5:55 am
- Forum: General Discussion
- Topic: Modified Ikea enclosure
- Replies: 55
- Views: 106477
Re: Modified Ikea enclosure
This is the one I built from scratch. The bottom cabinet is for filament storage and the printer section is temperature controlled. One thing I really like about this design is the slide-down door, since you can open and close it without a big door swinging open. It's only possible to do that when ...
- Wed Oct 12, 2016 7:18 pm
- Forum: General Discussion
- Topic: Referral Program
- Replies: 11
- Views: 14659
Re: Referral Program
Yep, he sold me!